Seite 1
INTRODUCTION This USB 3.0 enclosure is for the use of 3.5” SATA I/II/III HDD/SSD, made from aluminum alloy material for superior heat dissipation and finished with sandblasted appearance. CHIEFTEC CEB-7035S is your perfect storage solution. FEATURES » Sandblasted finish apperance Place the hard drive in the enclosure.
Seite 2
Slide hard drive into SATA connector and tighten the screws Connect the USB 3.0 cable to the PC, the HDD will be recognize. If you need to replace the hard disk, close all windows, remove devices safely and the HDD to stop running. Then follow the instructions from step 1. to 6. to remove and replace the HDD.
Seite 3
SPEZIFIKATIONEN Gewicht 495g Konformität Anschluss USB 3.0 / USB 2.0 Material Aluminum & Plastik Betrieb: 10% - 90% Betrieb: 0°C ~ 70°C Luftfeutigkeit Temperatur Lagerung: -5% - 95% Lagerung: -10°C ~ 75°C USB 3.0: 5Gbps Power & HDD Zugriff Datentransferrate USB 2.0: 480Mbps Abmessung 200x128x32 mm (L/B/H)
Seite 4
Schieben sie die Festplatte in den SATA Anschluss und fixieren sie die Festplatte unterseitig mit denen im Lieferumfang enthaltenen Schrauben. Unter Verwendung des im Lieferumfang befindlichen USB 3.0 Kabels, verbinden Sie nun das Festplattengehäuse mit dem PC. Das System erkennt das Gerät automatisch (Plug & Play) und kann verwendet werden.