Transport And Storage; Technical Specifications - Batavus XF3 Betriebsanleitung

•
After exercising, clean the equipment with a soft,
absorbent cloth. Do not use solvents.
•
Never remove the equipment's protective casing.
•
The electromagnetic brake forms a magnetic field
that may damage the mechanism of a watch, or the
magnetic identification strip on a credit or cash card,
should they come into immediate contact with the
magnets. Never attempt to detach or remove the
electromagnetic brake!
•
The electromagnetic brake is based on
electromagnetic resistance; resistance level is
electronically measured and shown as watt reading
on the display. Due to the measurement system,
your Batavus crosstrainer need not be re-calibrated
when assembled, serviced and used according to
this Owner's Manual.
MALFUNCTIONS
Despite continuous quality XF3, defects and
malfunctions caused by individual components
may occur in the equipment. In most cases it's
unnecessary to take the whole device in for repair,
as it's usually sufficient to replace the defective part.
If the equipment does not function properly during
use, contact your Batavus dealer immediately.
Always give the model and serial number of your
equipment. please state also the nature of the
problem, conditions of use and purchase date.
If you require spare parts, always give the model,
serial number of your equipment and the spare part
number for the part you need. The spare part list
is at the back of this manual. Use only spare parts
mentioned in the spare part list.

TRANSpORT AND STORAGE

please follow these instructions when carrying
and moving the equipment about, because lifting
it incorrectly may strain your back or risk other
accidents:
Always switch the power off and unplug the power
cord before you start moving the equipment
around!
For transportation or moving of the device, two
grown-ups are needed. Remain standing in front of
the device on each side and take a sturdy grip at the
handles. Lift the front of the device so as to lift the
rear of the device on the wheels. Move the device
and carefully put it down to its new place.
Transport the equipment with caution over
NOTE!
uneven surfaces, for example over a step. The
equipment should never be transported upstairs
using the wheels over the steps, instead it must be
carried. We recommend that you use a protective
base when transporting the equipment.
To prevent the equipment malfunctioning, store in
a dry place with as little temperature variation as
possible and protected from dust.
XF3_5_LOCKED.indd 13
O W N E R ' S M A N U A L

TECHNICAL SpECIFICATIONS

Length .................................................182 cm
Width ...................................................71 cm
Height ..................................................168 cm
Weight .................................................65 kg
The Batavus XF3 meets the requirements of the EU's
EMC Directives on electromagnetic compatibility
(89/336/EEC) and electrical equipment designed for
use within certain voltage limits (73/23/EEC). This
product therefore carries the CE label.
The Batavus model XF3 meets EN precision and
safety standards (Class A, EN-957, parts 1 and 9)
for fitness devices. The precision of the capacity
measurement is secured during manufacturing
by adjusting the brake with a dynamometer.
Calculation of exercise capacity is based on rotation
speed and moment.
Due to our continuous policy of product
development, Batavus reserves the right to change
specifications without notice.
The instructions must be followed carefully
NOTE!
in the assembly, use and maintenance of your
equipment. The warranty does not cover damage
due to negligence of the assembly, adjustment
and maintenance instructions described herein.
Changes or modifications not expressly approved by
Batavus will void the user's authority to operate the
equipment!
WE WISH YOU MANY ENjOYABLE TRAININGS WITH YOUR NEW
BATAVUS TRAINING pARTNER!
G B
•
X F 3
13
14.7.2008 13:55:23