Hama Fuel Up Bedienungsanleitung Seite 3

Note – Capacity
• The capacity is always shown when the
Power Pack is charging.
• Each status LED corresponds to 25%
of the capacity. When an LED is
permanently illuminated, this indicates
that this capacity level has already been
reached. The Power Pack is charged to at
least 75% if three LEDs are illuminated,
and the fourth is flashing.
• If all four status LEDs light up, the full
capacity is available.
Warnung – Battery
• Only use suitable charging devices or USB
connections for charging.
• As a rule, do not charge devices or USB
connections that are defective and do not
try to repair them yourself.
• Do not overcharge the product or allow the
battery to completely discharge.
• Avoid storing, charging or using batteries
in extreme temperatures.
• When stored over a long period of time,
batteries should be charged regularly (at
least every three months).
4.2 Charging terminal devices
• Connect the microUSB charging/
connecting cable included to the one of
the two USB ports on the Power Pack
(OUT 5V/2,1A) and to the microUSB port
on your terminal device (mobile phone,
smartphone, etc.).
• The Micro-USB charging/connecting cable
included may not be suitable for the USB
connection on your terminal device. In this
case, use the USB cable that was included
with your terminal device.
• To start charging, press the button of the
Power Pack. The status LEDs show the
remaining capacity when the Power Pack
is charging.
• The current battery status of your terminal
device will appear on this device.
• Press the button of the Power Pack to stop
charging and to switch it off. The status
LEDs should switch off.
• The Power Pack will automatically switch
off after 10 seconds if it is not connected
to a terminal device.
3