Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Keep all safety instructions and instructions for future reference.
Care
Only clean the device when it is switched off and with the mains plug unplugged. Use a soft, lint-free cloth. This can be
slightly moistened if necessary. Avoid contact with electrical components and moisture. After cleaning, allow the device to
dry completely before putting it back into operation. Do not use aggressive cleaning agents.
Commissioning
Before commissioning, please check the correct installation of the protective screens again; there is a risk of injury if they
are not installed correctly. Generally, the device may only be operated when completely assembled. Make sure that the
connected supply cable is free of damage. Never operate a device with a defective supply cable. There is a risk of electric
shock. Position the device upright and stable. When positioning the fan, make sure that curtains or other objects do not
obstruct the air flow. Insert the power plug into a properly fused power socket.
Assembly
The base (10) of the fan consists of two parts. Push both parts together and secure them with the screws contained in the
delivery (13). Place the fan on the base. There is a rectangular recess in the base and the corresponding counterpart on the
underside of the fan. Make sure that the two parts are connected to each other. Now secure the base with six further
screws (13).
Open the flap to the water tank (9) on the back of the fan and fill it with distilled water. Check the water level indicator (8)
on the front of the unit to avoid overfilling the tank. The water level should not be higher than the MAX mark and not lower
than the MIN mark. The size of the tank is approximately 5 litres.
Attention: Only fill the tank when the mains plug is disconnected!
Operation
Insert the mains plug (7) into a socket and switch on the fan using the remote control (11) or the control panel (1).
The device beeps once and signals that it is in standby mode.
You can control the functions of the fan from the control panel (1) or the remote control. The control display (2) shows you
which function you have selected.
14. "ON / OFF" Press this button to turn on the device. The device will start at the slowest speed and the temperature
(20) will be shown on the control display.
Press the button again to turn off the device.
15. "SPEED" The device has 3 different output levels.
23. Indicator
16. "TIMER" Setting working time , Timer is 1H,2H,3H,4H,5H,6H,7H,8H,9H,10H,11H,12H,13H,14H,15H
22. Indicator
17. "WATER COOLING" The device has a room humidifying function which contributes to an additional cooling effect.
24. Indicator
18. "SWING" The device is equipped with an oscillation function that allows the fan to oscillate with simultaneous
ventilation.
21. Indicator
19. "WIND MODEL" The device has 2 different fan modes.
Werbung
