ATEX DM1.1-30 Bedienungsanleitung Seite 7

ATEX Dipmeter
To test the system
Hold the probe centre pin against the stud on the back of the reel axle at the same time touch the
probe body against the screw on the frame. The buzzer will sound if the system is ok. Sensitivity
should be 8. Please refer to section 2.2 Back – General Operational Features.
General

Avoid sharp edged casing

Avoid entanglement with other equipment in boreholes and wells.

Do not use as guide to backfilling with sand etc., Instrument may get locked in sand.

Rewind tape onto reel after each use
Warranty is conditional upon adherence to these guide lines.
Geotechnical Instruments (UK) Ltd
LFWATOM001 Iss.09
Page 7 of 15