RIDGID B-500 Bedienungsanleitung Seite 11

3. Turn the clamp screw to open the swing arms to
position wide enough for mounting to work piece.
4. Securely grasp the beveller and place on the pipe with
guide rollers on the outside diameter (guide rolls to the
side that gets the bevel for flat plate) and drive roll
inside the pipe (side away from the bevel). Make
sure the wear plates on the beveller are flush to the
end of the pipe or plate edge. Be careful not to hit the
pipe or plate with the Cutter Head to prevent damage
to the inserts. (See Figures 8 & 9.)
Figure 8A – Placing Beveller on Pipe
Figure 8B – Wear Plate Flush To End of Pipe
Model B-500 Transportable Pipe Beveller
6" (0.15 m)
Figure 9A – Beveller On Plate
Figure 9B – Installing Beveller on Plate
5. Tighten the clamp screw hand tight
plus an additional
(Figure 10) with the supplied hand
crank to grip the material between the guide rollers and
the drive roll. Make sure that the beveller is secure to
Wear
Plates
the material and the beveller and material is stable.
Remove the hand crank. Do not leave the hand crank
on the clamp screw. Do not attempt to bevel unless the
beveller is secure to the work piece.
Figure 10A – Hand Tighten Clamp Screw
Min.
3 / turn (270°)
4
9