Output Format - Samsung Ssa-R2001 Kurzanleitung

Initialization

OUTPUT FORMAT

You can adjust the output format of the numeric values from the keypad.
You can select 4/8 bit Burst or 34bit Wiegand.
Adjust the format according to the controller receiving the keypad input.
1. To change the output format, use the switch
on the rear of the product.
2. See the table below to make adjustment as
needed.
❖
Output Format
SW #1 SW #2
ON ON
ON OFF
OFF ON
OFF OFF

M
All switches are defaulted to "OFF".

Before you change the output format, you must disconnected the power.
8
_Initialization
Output Format of Card
34bit Wiegand + RS-232
34bit Wiegand + RS-232
34bit Wiegand + RS-232
34bit Wiegand + RS-232
ON
1 2
Output Format of Keypad
34bit Wiegand+RS-232
34bit Wiegand+RS-232
4 bit Burst
8 bit Burst (Default)
SAL
SAM
Sam
TEL
SAM
148
Tol F
www
www
www