Operation Shaking - Hettich Benelux TH 21 Bedienungsanleitung

Start
process:
Displayed
remaining
time:

Operation Shaking

For shaking, the mains switch on the
back of the system must be switched
on.
With the scaled slider, the shaking
frequency can be set to a value
between 0 and 1.500 rpm in steps of 250. For fine-tuning, in steps of 10, use
– + .
the keys and
display for three seconds. The recommended min. rotational speed is 80 rpm,
lower rotational speeds can also be set.
Please note that the HeatingThermo Shaker MHR 11 will shake immediately if
the shaking frequency is set, independent of the start of the tempering.
If the rotational speed is to be displayed during a running process, decrease or
increase the rotational speed with + and – by 10 rotations, the current rota-
tional speed value is then displayed for three seconds.
The currently entered rotational speed is indicated on the
To start a process push
Start / Stop
. The preset process
time only starts if the set value is
reached. If a process time is preset,
the horizontal hyphen flashes. After
the expiration of the time, the heat-
ing switches off.
The time remaining until the end of
the process is indicated on the dis-
play with flashing "
OK
for 10 seconds and releasing the
button, you get back to the tem-
perature display.
9
: .
"
By pushing