Mitel ST Voice Switch Wall Mount Kurzanleitung Zur Installation Seite 3

Preparing the Installation Surface
355 mm
(14 ")
63 mm
(2 - 1/2 ")
Preparing Drywall for ST Voice Switch Wall Mount Bracket
The minimum wall area required for mounting a ST Voice Switch Wall Mount Bracket is
1.
17.50 inches (444 mm) by 14 inches (355 mm).
Minimum drywall thickness: 3/8 inch (10 mm).
Maximum drywall thickness: 5/8 inch (16 mm).
2. Punch three pilot marks using the wall mount as a
template to determine the mark placement.
At each pilot mark, insert the screw-in drywall anchors
3.
flush to the drywall.
Insert one Phillips sheet metal screw at the top position
4.
partially into the drywall anchor. Leave 1/8 inch (3.2 mm)
of the screw shank exposed.
Placing the ST Voice Switch Wall Mount Bracket on the Wall
1. Hang the empty ST Voice Switch Wall Mount Bracket over the Phillips sheet metal screw
you inserted at the top position, and then tighten the screw to affix the bracket to the wall.
2. Install round head screws in the bottom positions to secure the bracket to the wall.
444 mm
(17 - 1/2 ")
222 mm
(8 - 3/4 ")
317 mm
(12 - 1/2 ")
54 mm
(2 - 1/8 ")
51 mm
(2 ")
63 mm
(2 - 1/2 ")
3.2 mm
(1/8 ")