Installing The Battery Pack - Motorola ML910 Kurzanleitung

Installing the Battery Pack

CAUTION:
There is danger of damage if the battery is incorrectly installed.
Do not attempt to disassemble the battery pack.
To install the battery pack, follow these steps:
1. Make sure the computer is not on or connected to the AC
power.
2. Loosen the four screws and lift the battery pack compartment
cover to take it off the computer.
3. Insert the battery pack into the compartment.
4. Replace the compartment cover and secure the four screws.
ML910 Rugged Notebook - Quick Reference Guide
Initializing the Battery Pack
You need to initialize the new battery pack before using it for the
first time or when the actual operating time of a battery pack is less
than expected.
Initializing is the process of fully charging, discharging, and then
charging that can take several hours.
1. Make sure the computer is turned off. Connect the AC adapter
2. After the battery pack is fully charged, turn on the computer.
3. Disconnect the AC adapter and leave the computer on until
4. Connect the AC adapter to fully charge the battery pack.
8
to fully charge the battery pack.
the battery is fully discharged. The computer will shut down
automatically.