Clatronic BQ 3507 Bedienungsanleitung Seite 32

• Fill the grill pan with water to a maximum of 1 litre.
Do not fill beyond the "MAX" mark.
• Allow the device to completely cool down before putting away.
• Do not try to repair the appliance on your own. Always contact an
authorized technician. If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
• This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental capa-
bilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children
unless they are older 8 years and supervised.
• Keep the appliance and its cord out of reach of children less than
8 years.
Overview of the Components /
Delivery Scope
1 Grid
2 Handle
3 Housing
4 Heating element with thermostat and temperature control
5 Indicator light
6 Grill pan
7 Windshield
Unpacking the Device
1. Unpack the device.
2. Remove all packaging materials such as foils, filling
material, cable ties and cardboard packaging.
3. Check the scope of delivery.
4. If the contents of the packaging are incomplete or display
obvious damage, do not operate the appliance. Return
promptly to the dealer.
32
BQ3507_IM_new
NOTE:
There may still be dust or production remains on the device.
We recommend that you clean the device as described
under "Cleaning".
Installation
Please refer to the illustrations.
1. Pour 1 litre of cold water into the grill pan up to the "MAX"
mark. A "MAX" mark can be found on the back section of
the grill pan.
CAUTION:
• Always grill with water to avoid overheating.
• Do not fill with water above the "MAX" mark in order
not the damage the heating element.
2. Fit the heating element with the thermostat onto the hous-
ing. Slide the thermostat from above into the recess of the
housing. Press gently until it audibly clicks into place.
3. If required, fit the windshield.
17.10.16