Casio YA-P10 Bedienungsanleitung Seite 46

To start a pointer operation
1.
Press the pointer left mouse button or right mouse button.
• This turns on the pointer and causes the link indicator to start flashing.
2.
Holding the pointer securely, point the pointer tip at the projected image.
• The link indicator will go from flashing to lit when a link between the pointer and projector is
established.
• Pointer operations (page E-17) are enabled at this time.
NOTE
After establishing a connection between the pointer and the projector, the link indicator will go
out if you move the pointer tip so it is not pointed at the projected image. You can reestablish
the connection by pointing the pointer tip at the projected image within about one minute after
the link indicator goes out.
If you do not perform any operation for a few minutes after the link indicator goes out, the
pointer will turn off automatically.
E-16