Back Carry; Accessories; Bib; Harness Covers - Nuna CUDL Handbuch

Back Carry

25–35 lb (11–16 kg)
9+ months
Back Carry Position
We recommend practicing this method a few times without a child in the
carrier before attempting it with your child.
Child should NEVER be facing out (away from you) in back carry mode.
1
- With your child in the baby carrier facing inward, loosen both shoulder
adjustment straps (DO NOT unbuckle). (35)
2
- Slide your right arm out of the right shoulder strap while cradling your child
with your left arm. (36)
3
- Slide your left arm under the shoulder adjustment strap on the side while
cradling your child with your right arm. (37)
4
- Cradling your child with your right arm, guide your child to your right hip
using your left arm. (38)
5
- Still supporting your child, grab the shoulder strap with your left hand and
pull it down over your shoulder. (39)
6
- Slightly lean forward and move your child onto your back. (40)
7
- Slide your left arm up through the shoulder adjustment strap on the side
while cradling your child behind your back with your right arm. (41)
8
- Slide your right arm down through the shoulder strap while cradling your
child with your left arm. Both shoulder straps should now be secure around
your shoulders. (42)
15 CUDL™ instructions
9
- Pull down on the shoulder adjustment straps to tighten. Adjust the yoke up
or down vertically and side to side. (43)
10
- Roll up the excess length of the shoulder adjustment straps and use the
elastic loop to wrap around the rolled up strap to store it out of the way.
(44)
11
- Make sure your child is comfortable and securely seated in the baby carrier.
Adjust the straps around your child and check to make sure all buckles and
snaps are secure. Allow room for your child's head movements and keep
child's face free from obstructions. (45)

Accessories

Bib

1
- Make sure the head support is folded down and secured in place with the
lower head support buttons. (46)
2
- Store the extra length of the shoulder buckle adjustment in the pocket on
the shoulder buckle strap. (47)
3
- Cover the front of the head support with the front of the bib and slide both
head support buttons through the button holes on the bib. (48)
4
- Fold and tuck the bib over the top edge of the head support. (49)
5
- Wrap both side edges of the bib around the shoulder buckle strap. The
back edge of the bib is slid between the shoulder strap and shoulder buckle
strap. The front edge of the bib is laid over the shoulder buckle strap. (50)
6
- Attach the sides of the hook and loop. Make sure the bib is laying flat and is
secure to the top edge of baby carrier. (51)

Harness Covers

1
- Unbutton the head support and fold it down. (52)
2
- Store the extra length of the shoulder buckle adjustment in the pocket on
the shoulder buckle strap. (53)
3
- Slide the harness cover between the shoulder strap and the shoulder buckle
strap. (54)
4
- Slide the button on the shoulder buckle strap through the button hole on
the harness cover. (55)
5
- Attach the hook and loop. Make sure the bottom edge of the harness cover
is tucked behind the head support. (56)
6
- Repeat on the other side. When both harness covers are secure, attach
both bottom head support buttons into the button holes on the head
support. (57)
16
CUDL™ instructions