Frontal Mower Bar Application; Airborne Noise; Handlebar Vibration - NIBBI FC 120 Bedienung Und Wartung

IT
GB
F
D
DK
RO
Connection to machine
The mower bar is attached to the machine
by means of the Quickfi t connection.
Mower height adjustment
When working on bad terrain, it is necessary
to adjust the mower's cut height in the
following way:
- Loosen nut 1.
- Bring the skid pad back to wanted
position 2
- Lock the nut again
- Carry out adjustment on both skid pads
Blade holder adjustment
- Loosen fi xing screws 3.
- Turn the adjustment screws 4.
- Tighten the fi xing screws again
N.B.: Excessive friction between the blade

AIRBORNE NOISE

Maximum level of weighted equivalent continuous sound pressure: 83 dB (A)

HANDLEBAR VIBRATION

Measurement with weighting according to ISO 5349: 13,4 m/s
FRONTAL MOWER BAR APPLICATION (Fig. 21)
Fig. 21
holder and the blade must be avoided in
order to guarantee good functioning.
Mower blade replacement
- Loosen screws 5.
- Remove blade catch 6
- Slip off the blade.
To re-mount the blade carry out the same
operations but in reverse order.
SERVICING THE BAR WITH CONNECTING
ROD-CRANK MECHANISM
Each time the mower is used apply grease
to points 7 and 8.
22
2