Electrical Safety - KooZzzi 549015 Handbuch

• Do not use the appliance near bathtubs,
showers, basins or other vessels containing
water.
• Do not immerse the appliance in water or
other liquids. If the appliance is immersed
in water or other liquids, do not remove
the appliance with your hands.
Immediately remove the mains plug from
the wall socket. If the appliance is
immersed in water or other liquids, do not
use the appliance again.

Electrical safety

• Before use, always check that the mains
voltage is the same as the voltage on the
rating plate of the appliance.
• The appliance is not intended to be
operated by means of an external timer or
separate remote-control system.
• Make sure that water cannot enter the
contact plugs of the mains cable.
• Always fully unwind the mains cable.
• Make sure that the mains cable does not
hang over the edge of a worktop and
cannot be caught accidentally or tripped
over.
• Keep the mains cable away from heat, oil
and sharp edges.
• Do not use the appliance if the mains cable
or the mains plug is damaged or defective.
If the mains cable or the mains plug is
damaged or defective, it must be replaced
by the manufacturer or an authorised
repair agent.
• Do not pull the mains cable to disconnect
the mains plug from the mains.
• Disconnect the mains plug from the mains
when the appliance is not in use, before
assembly or disassembly and before
cleaning and maintenance.
Safety instructions for rechargeable
bed warmers
• Do not use the bed warmer outdoors.
• Do not use the bed warmer in humid
surroundings.
• Keep the bed warmer away from heat
sources.
• Make sure that the bed warmer does not
come into contact with flammable material.
• Beware of hot parts. The bottle will
become hot during the charging process.
Only use the handgrip to hold the bottle
when it is hot.
U.K. Wiring instructions
The wires in the mains lead are coloured in
accordance with the following code:
BLUE NEUTRAL
BROWN LIVE
As the colours of the wire in the mains lead of
this appliance may not correspond with the
colour markings identifying the terminals on
your plug, proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter L or coloured red.
If a 13Amp (BS1363) plug is used, a 13Amp
(BS1362) fuse must be fitted, or if any other
type of plug is used, a 13Amp fuse must be
fitted, either in the plug or adaptor, or on the
distribution board.
This is a double-insulated appliance and does
not need an earth connection.
Warning! On no account should either the live
or neutral wires be connected to the earth
terminal.
Disclaimer
Subject to change; specifications can be
changed without further notice.
10