HP Laser MFP 130 serie Kurzübersicht Seite 2

Set up a wireless connection (wireless models only)
As directed in the setup guide, download and install the HP printer software, and follow the instructions in the
software to connect the printer to your wireless network.
When the printer has successfully connected to your wireless network, the Wireless light
panel stops blinking and glows steady blue. If the light does not turn steady blue, try the following solutions.
Solve wireless problems
Problem Cause/Solution
The Wireless Wireless connection mode is turned off. Try the following:
light is off.
1. Press the Wireless button
2. On the printer, when the Wi-Fi On/Off message appears on the display, select On.
3. If the Wireless light
4. If the Wireless light
The Wireless Wireless connection mode is on but the wireless network connection is not set up yet. Try the
light is following solutions in order:
blinking blue.
1. Verify that the printer is within the range (30 m or 100 ft) of the wireless network.
2. If you are using a USB cable to temporarily connect the printer and computer during set
3. Restore the wireless network settings:
4. Restart the printer and the router.
5. Manually connect the printer to your wireless network. Use Wi-Fi Protected Setup (WPS) if
6. Uninstall and reinstall the HP printer software.
The Wireless The printer driver might not be installed. Try installing or reinstalling the printer driver, and then
light is try printing again.
on, but you
If you still can't print wirelessly, the printer and your computer or device might be connected to
cannot print
different networks. Try the following:
wirelessly.
1. Check the network that the computer is connected to.
2. Check the printer's network name (SSID) info on the Configuration Report/Network
3. Resolve any connection issues, and then continue to install the software.
2
connection is established. You can now print wirelessly.
installation and follow the instructions in the software to set up a wireless connection. Also,
see the instructions below under "The Wireless light
up, do not connect the USB cable until the software prompts you to do so. If you connected
the cable before being prompted, unplug the cable and then restore the wireless network
settings as directed in the next step.
a. Remove the USB cable from the printer.
b. On the printer, press the Menu button
c. After the Wireless light
your router supports it. See the WPS instructions in the next section.
Summary. To print the report, press the Menu button
Conf....
on the printer control panel.
turns steady blue, wireless connection mode is on and the wireless
blinks blue, the printer is in wireless setup mode. Continue software
and select Network > Wi-Fi Default > Restore....
starts blinking blue, continue to install the software.
on the printer control
is blinking blue."
and select Network > Network