Elem Co-Ligne MAX2300K-G Bedienungsanleitung Seite 7

WARNING
Read this manual carefully before using
the machine, for your own safety.
SAFETY INSTRUCTIONS
When using the machine, always observe
the enclosed safety instructions as well as
the additional safety instructions.
ADDITIONAL SAFETY INSTRUCTIONS FOR
ANGLE GRINDERS
Do not cut or grind light metal with a magnesium
content exceeding 80%; since this type of metal is
flammable.
Do not use any other accessories than
grinding wheels.
Make sure that the speed stated on the
grinding wheel is larger or the same as the speed of
the angle grinder given on the nameplate.
Do not cut workpieces requiring a maximum
depth of cut exceeding that of the grinding wheel.
Make sure that the grinding wheel has the
correct dimensions and fits properly on the spindle.
Treat grinding wheels with great care in
accordance with the instructions supplied with the
grinding wheel.
Inspect the grinding wheel before every
use. Do not use cracked or otherwise
damaged grinding discs.
Make sure that the grinding wheel is
mounted in accordance with the instructions.
After mounting the grinding wheel let the
machine run at no load speed in a safe
area. If the machine vibrates strongly or if
you see damages in the grinding wheel,
switch off the machine immediately and
try to establish the cause.
Do not use adapters or other aids to
mount grinding wheels with a different spindle
diameter.
Make sure that the workpiece is properly
supported or fixed.
Never use a cut-off wheel for deburring.
Make sure that sparks cannot hit any
persons or set flammable materials alight.
Always wear safety goggles, hearing
protection and if necessary other
protective means, such as working
gloves, coat, hard hat, etc.
Mount the screening guard. Never use the
machine without screening guard fitted.
Make sure that the ventilation openings
are kept clean. Especially when working in
a dusty environment.
- Before removing dust always unplug
the tool.
- Do not use brushes of metal or the like
to remove dust and avoid damaging the
internal parts.
Beware that after switching off the tool the
wheel continues to rotate for a short
period.
GB ANGLE GRINDER
ELECTRICAL SAFETY
Always check that the power supply corresponds to
the voltage on the rating plate.
DESCRIPTION
Your angle grinder has been designed for
grinding and cutting masonry and steel.
1 On/off switch
2 Lock-off button
3 Lock knob
4 Spindle
5 Guard
6 Side handle
7 Carbon brush holder
MOUNTING AND REMOVING THE GUARD
Never use the machine without guard.
MOUNTING AND REMOVING A GRINDING
WHEEL
the tension nut (11) using the spanner (12)
supplied.
reverse order .
Prior to mounting or removing a grinding wheel
always unplug the tool.
MOUNTING AND REMOVING THE SIDE HANDLE
mounting holes.
SWITCHING ON AND OFF
depressed and press the on/off switch (1).
switch.
CLEANING AND MAINTENANCE
The machine does not require any special
maintenance.
are kept clean. Especially when working in
a dusty environment.
- Before removing dust always unplug the tool.
- Do not use brushes of metal or the like
to remove dust and avoid damaging the internal
parts.
CHECKING AND REPLACING THE CARBON
BRUSHES
The carbon brushes must be checked on a
First remove the guard as described below.
Place the guard (5) on the machine as shown.
Tighten screw (8) firmly.
To remove the guard, proceed in reverse order.
Place the machine on a table, guard up.
Fit the spacer (9) onto the spindle (4).
Place the grinding wheel (10) on the spacer.
Screw the tension nut (11) onto the spindle.
Press the lock knob (3) and firmly tighten
Release the lock knob.
To remove the grinding wheel, proceed in
Tighten the side handle (6) in one of the
To switch the tool on, keep the lock-off button (2)
To switch the tool off, release the on/off
Make sure that the ventilation openings
7