Led Indicators - Schumacher PMI7AOBD Bedienungsanleitung

1.8 Do not permit the internal battery of the Memory Saver to freeze. Never charge a frozen
battery.
1.9
Make sure that the Memory Saver cable connectors make tight connections.
2. FEATURES
1
3. CHARGING THE INTERNAL BATTERY OF THE MEMORY SAVER
IMPORTANT: CHARGE IMMEDIATELY AFTER PURCHASE, AFTER EACH USE,
AND EVERY 30 DAYS TO KEEP THE MEMORY SAVER'S INTERNAL BATTERY
FULLY CHARGED.
3.1

LED INDICATORS:

To check the internal battery status, press the red button on the front of the Memory Saver.
• A red light
the Memory Saver.
• A yellow light
but should be recharged as soon as possible.
• A green light
3.2 CHARGING THE INTERNAL BATTERY USING THE INCLUDED WALL CHARGER:
IMPORTANT
charger or using the included charger for any other purpose could result in personal
injury or property damage.
1. To charge, plug the included wall charger into the charger plug on the side of the
Memory Saver.
2. Confirm the AC outlet voltage matches the input voltage of the wall charger.
3. Plug the wall charger into the electrical wall outlet.
4. The CHARGING
5. The FULL
This could take up to 72 hours, depending on the age and condition of the battery.
The charger will automatically go into maintain mode and maintain the battery at full
charge without damaging it.
6. Charge the Memory Saver as soon as possible after use.
4. OPERATING INSTRUCTIONS
Use the Memory Saver to save the vehicle's on-board diagnostic computer settings
(radio programs, diagnostic codes, etc.) while the battery is disconnected from the
vehicle during repair or maintenance.
4.1 BEFORE USING THE MEMORY SAVER
Make sure that the Memory Saver's internal battery is fully charged. See LED
INDICATORS section.
WARNING
Memory Saver's OBD port) and cannot come into contact with the negative cable or
2 3
indicates a 50% or less charge, and you should immediately recharge
indicates a 50% to 75% charge. The Memory Saver may be used
indicates the internal battery is fully charged.
Only use the charger that was included with the Memory Saver to
charge the internal battery of the Memory Saver. Using any other
(red) LED will light, indicating charging.
(green) LED will light when the battery has reached full charge.
Before disconnecting the positive cable from the battery, it is extremely
important to realize this cable is live (it is receiving 12V from the
1. OBD (On Board Diagnostic) Connector
with a 6 Foot Cable
4
2. Charging Status Lights
3. Internal Battery Status Light
4. Internal Battery Status Test Switch
5. Internal Battery Charger Connector
(on side, not shown)
6. Velcro Strap (not shown)
3
• •