Loop Detection; Table 137: Cli "Loop Detection" Configuration - WAGO 852-0603 Handbuch

272 Anhang
11.3.3.6

Loop Detection

Table 137: CLI "Loop Detection" Configuration

Node
enable
configure
configure
configure
interface
interface
interface
interface
configure
if-range
if-range
if-range
Example
L2SWITCH(config)#loop-detection enable
L2SWITCH(config)#interface 1/0/1
L2SWITCH(config-if)#loop-detection enable
Handbuch
Version 1.1.0
Command
show loop-detection
loop-detection
(disable|enable)
loop-detection address
MACADDR
no loop-detection address
loop-detection
(disable|enable)
no shutdown
loop-detection recovery
(disable|enable)
loop-detection recovery
time VALUE
interface range
gigabitethernet1/0/PORTLI
STS
loop-detection
(disable|enable)
loop-detection recovery
(disable enable)
loop-detection recovery
time VALUE
WAGO-ETHERNET-Zubehör 852
852-0603 Industrial-Managed-Switch
Description
This command displays the current loop detection
configurations.
This command disables/enables the loop detection
on the switch.
This command configures the destination MAC for
the loop detection special packets.
This command configures the destination MAC to
default.
(00:0b:04:AA:AA:AB)
This command disables/enables the loop detection
on the port.
This command enables the port. It can unblock port
blocked by loop detection.
This command enables/disables the recovery
function on the port.
This command configures the recovery period time.
This command enters the interface configure node.
This command disables/enables the loop detection
on the ports.
This command enables/disables the recovery
function on the port.
This command configures the recovery period time.