Chapter I Overview; Product Features - SATA AE5201 Gebrauchsanweisung

Chapter I Overview

1.1 Product Features:

- PCB control
- Pneumatic unlocking, safe and reliable
- Wire rope fracture protection, avoiding wire rope fracture risks
- Ultra long body, with the effective platform length of 4,620mm
- High-strength material, improving safety coefficient by 1.5 times
- Standard secondary lifting trolley
Rated lifting
Drive mode
capacity
Direct-acting
4.5T
hydraulic cylinder
Maximum lifting Overall length of
height bench
1900mm 4620mm
1.2 Main structure principles of the product
Lifting mechanism:
The hydraulic cylinder (pull type) is installed inside the left bridge. When the hydraulic oil enters the front chamber of the cylinder, the
piston rod moves backward, and drives the front and rear beams to move upward as a whole via the lifting wire rope.
Supporting mechanism: The left and right bridge plates are installed on the front and rear beams to form a supporting platform. After the
vehicle enters the working area, the front and rear wheels of the vehicle shall be basically on the centerlines of the left and right bridge
plates. The secondary lifting mechanism can be moved between the left and right bridge plates and the star bar of proper length can be
used to adapt for the vehicles of different chassis heights.
Balance mechanism: Four lifting wire ropes are synchronized forcibly in order to keep balance during the lifting/lowering of the vehicle. In
this way, the four wire rope ends fixed on the post shall be preset to keep the tension of four lifting wire ropes consistent.
Manual safety mechanism: The four posts are equipped with the safety guard. During the lifting of sliding table, the safety block leans
against the safety guard and works under the action of the spring. To lock the sliding table, press the LOCK button, after which the sliding
table will descend and the safety block will be stuck in the safety guard. To lower the sliding table, press the DOWN button, after which the
sliding table will rise a little, the safety block will be unlocked pneumatically, and then the sliding table will descend automatically.
Wire rope fracture protection safety mechanism:
The front and rear beams are equipped with safety claws, which are usually held down by the lifting wire rope through the safety wheel
to make the safety claws draw inward. When the wire rope fractures, the safety claws will recover under the action of the spring and get
stuck in the positioning board at the same time.
Working travel of safety mechanism:
These safety mechanisms will work when the height of sliding table is within the range of 270mm (both front and rear beams off the
ground) to 1,900mm (effective lifting height).
Presetting for levelness:
Keep the left and right bridges horizontal by adjusting the four adjusting screws on the four posts.
26
AE5201/AE5201-3
Hydraulic station
2.2 KW aluminum
alloy
Inner width of the
post
3040mm
中文
EN
Cylinder
Unlock method
protection
Limit switch PCB control,
Width of internal
Power supply
baffle
1PH, 220VAC, 2.2KW,
1080mm
Motor with aluminum alloy housing
DE RU KO PT JA
Minimum lifting
height
227mm
ES