Mediclinics M092A Montage- Und Benutzerhandbuch Seite 18

AIR HOSE CONNECT M092A
A – Place the wire through the adaptor tube cut, placing the gasket in the tube hole.
B – Place the clamp in the adaptor tube and connect it to the 'air unit'. Place the adaptor tube as
high as possible not forcing the wire. Firmly tight the clamp.
C – Connect the earth terminal.
AIR HOSE CONNECT M093A
A – Place the clamp in the adaptor tube and connect it to the 'air unit'. Firmly tight the clamp.
B – Connect the earth terminal.
IR SENSOR WIRE CONNECTION AND CASING CLOSE
A – Connect the sensor IR wire to the electronic board.
B – Route the wire inside the plastic protector and place it in the casing.
C - Carefully place the casing on the base of the device. To do so place it over the base with a
slight incline from top to bottom, in such a way that the tab in the casing correctly inserts into the
corresponding slot in the base.