User manual / Bedienungsanleitung
6.4 Manual cleaning
To set your own parameters for the cleaning process manually:
• After you have placed and fixed the record with the Seal record clamp, close the cleaning and
vacuum assembly.
• Press the "POWER" button to start the sonic cleaning function and rotation of the record.
• Press the "LIQUID" button to apply cleaning fluid to the record. Holding down the button for
longer applies more fluid. Adjust this according to the desired quantity of cleaning fluid.
• After about 3 or 4 rotations, change the platter direction by pressing the "PLATTER" button. We
recommend 3 or 4 turns in each direction. By turning the "PLATTER SPEED" knob you can vary
the rotational speed to further fine tune the cleaning process.
• Once you are happy with the cleaning, press the "VACUUM" button. This will stop the sonic
cleaning function and start the vacuum drying process. After about 3 or 4 rotations, when the
record is visibly dry, switch off the suction by pressing the "VACUUM" button again.
• Press the "POWER" button to stop the record rotation.
• Open the suction arm. Now start the antistatic function (see 5.3, page 9). After completion of the
antistatic function the manual cleaning is complete and you can remove your record.
Page / Seite 10
© clearaudio electronic GmbH, 2020-04