Husqvarna K 7000 Ring Bedienungsanweisung Seite 12

WARNING: Make sure that the cutting blade
is in good condition and not damaged. A
damaged cutting blade can break and cause
serious injury.
1. Clean the surface of the cutting blade.
2. Remove the 2 locknuts on the support roller guard.
3. Loosen the 2 adjuster screws.
12
4. Remove the 2 knobs.
5. Remove the 4 screws that holds the support roller
guard with the 6 mm hex key.
6. Remove the support roller guard.
7. Install the cutting blade. Make sure that the inner
edge of the cutting blade is in the groove of the drive
wheel. Make sure that the guide rollers go into the
groove (A) in the cutting blade. Refer to
blade on page 11 .
Ring cutting
A
1461 - 001 - 17.02.2020