Master Code - Cisa Master Code Bedienungsanleitung

INTRODUCTION:
The safe is equipped with 2 opening codes:
•
- User code (for normal use).

MASTER CODE

- (for emergency opening in case the user code is forgotten).
• Before starting the " MEMORIZING a new
Get a pencil (which will be used for pressing the zero reset button).
•
All the safes are supplied with a service
•
MASTER CODE
is memorised.
MASTER CODE
OPENING WITH
• Press the button twice.
• Within 10 seconds enter the
• Press the button.
- If the code is correct the green LED will come on
- If the code is incorrect the red LED will come on
It will not be possible to turn the knob.
N.B.: opening with MASTER CODE cancels the user opening code.
MEMORIZING A NEW
STEP 1
Get a pencil.
•
Open the safe door using the
•
Within 10 seconds press the zero reset button on the back of the door using the blunt end of the pencil (see diagram). As soon as you
•
have pushed the reset button it will no longer be possible to turn the knob. The green LED
will remain on to indicate that the safe is waiting for a new code to be inserted.
- If at the end of the 10 seconds no new code is inserted the safe will emit an acoustic signal
and will revert to normal operating conditions.
• Within 20 seconds enter a new
button. Once the
LED to indicate that the safe is waiting for the new code to be confirmed.
- If at the end of the 20 seconds no new code is entered the safe will emit an acoustic signal
and will revert to normal operating conditions.
• Within 20 seconds enter again the new
If once the is pressed the verification was successful the two LEDs will go out
and a short acoustic signal
successful the two LEDs will be turned off
.
signal
MASTER CODE
No new
operating conditions.
CHECKING THE MEMORISATION OF THE NEW
STEP 2
- Press the button twice.
MASTER CODE
- Enter the
- Press
- Turn the knob in a clockwise direction:
- If the code is correct the green LED
- If the code is incorrect the red LED will come on and an error acoustic signal will be emitted
It will not be possible to turn the knob.
To help you remember the code, repeat the opening operation a few times.
N.B.: If the MASTER CODE is lost, it will not be possible to renew it.
The products described above have all the characteristics illustrated in the technical data in CISA S.p.A. catalogues and they are designed exclusively for the uses
described therein. CISA S.p.A. does not guarantee any operational features or technical characteristics unless they are expressly indicated. For special security
requirements Clients are requested to consult their dealer or installer or contact CISA directly for specific advice on the most suitable model for individual needs.
2
MASTER CODE
MASTER CODE
:
MASTER CODE
MASTER CODE
:
MASTER CODE
MASTER CODE
(min. 4, max. 12 characters) and press the
button is pressed the red LED will come on together with the green
MASTER CODE
will be emitted. On the other hand if the verification was not
and the safe will emit a much longer acoustic
will have been memorised and the safe will revert to normal
will come on and it will be possible to turn the knob in a clockwise direction to open the door.
INSTRUCTIONS FOR USING THE
" MASTER CODE "
" procedure you should read the instructions very carefully.
"666666", and after installation it is recommended that a new personal
and it will be possible to rotate the knob in a clockwise direction to open the door.
and there will be an accompanying error acoustic signal.
and press the button.
MASTER CODE
FUNCTION
ZERO RESET
BUTTON
PENCIL
:
GB