Installation; Installing The Batteries; Removing The Belt Clip; Installing The Belt Clip - Swissvoice TwinTop 400 Bedienungsanleitung

Installation

Removing the belt clip

1. Pull the belt clip latch forward (away from the TwinTop 400/400-L)
2. While pulling the belt clip latch, push up the belt clip as shown in Figure 1.

Installing the belt clip

1. Slide the belt clip into the slot as
shown in Figure 2.
2. A "click" indicates the belt clip is
locked into position.

Installing the batteries

Figure 3
1. Pull up the battery cover latch, lift up battery compartment cover.
2. Install the rechargeable batteries by following the orientation as shown in Figure 3
(the arrow is showing and pointing upward.)
3. Replace the battery compartment cover. See Figure 4.
Important
– Read the safety warnings before you charge the batteries.
– When charging TwinTop 400/400-L, use only the rechargeable batteries supplied.
– Don't try to recharge non-rechargeable batteries.
– Make sure the battery compartment cover is securely locked in place when you
are charging the batteries.
– Dispose of used batteries safely and in a way that will not harm the environment –
never try to burn them or put them anywhere, they could get burnt or punctured.
– Don't leave dead batteries in your TwinTop 400/400-L units. They might leak if
you do.
Figure 1
Figure 4
19
Belt clip
latch
Figure 2
Caution
Observe the proper bat-
tery polarity orientation
when installing batteries.
Incorrect positioning can
damage both the batte-
ries and the unit.