Herunterladen Inhalt Inhalt Diese Seite drucken

Happy Plugs Earbud Plus Wireless II Betriebsanweisung Seite 17

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 8
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by on or more
of following measures.
- Reorient or relocate the receiving antenna.
- Increase the seperation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
- This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
- This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
- Caution: The user is cautioned that changes or modifications not expressly
approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Certifications
The aim of EU's Waste Electrical and Electronic Equipment (WEEE) directives
2002/96/EC and the RoHS directive is to reduce waste from electric and
electronic products and to recycle as much of the materials as possible. Any
remaining waste should be virtually risk free to handle and the risk of hazardous
emissions should be minimal.
Recycling
For detailed information about how to recycle this product, please contact your
local recycling centre or store where you purchased the product.
Industry Canada Notice
For Your Attention
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference,and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
The term "IC: " before the certification/registration number only signifies that the
Industry Canada technical specifications were met. This product meets the
applicable Industry Canada technical specifications.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
ap-pareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement.
This Class B digital apparatus complies with Canada ICE-003.
CAN ICES-3(B)/NMB-3(B)
IC: 22014-WIRELESS2
FCC ID : 2AJYS-WIRELESS2
低功率電波輻射性電機管理辦法
第十二條
經型式認證合格之低功率射頻電機,非經許可,公司、商號或使用者均不得擅自變
更頻率、加大功率或變更原設計之特性及功能。
第十四條
低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象時,
應立即停用,並改善至無干擾時方得繼續使用。
前項合法通信,指依電信法規定作業之無線電通信。
低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備
之干擾。
IC Radiation Exposure Statement:
This equipment complies with Canada radiation exposure limits set forth for
uncontrolled environments. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Déclaration d'IC sur l'exposition aux radiations:
Cet équipement est conforme aux limites d'exposition aux radiations définies
par le Canada pour des environnements non contrôlés. Cet émetteur ne doit
pas être installé au même endroit ni utilisé avec une autre antenne ou un
autre émetteur.
Model name : Earbud Plus Wireless II
Manufacturer : Happy Plugs AB, Kungsgatan 4B,
111 43 Stockholm, Sweden
FULL WARRANT Y SECTION ONLINE
AT HAPPYPLUGS. ZENDESK.COM/

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für Happy Plugs Earbud Plus Wireless II

Inhaltsverzeichnis