Werbung
© Danfoss A/S (IA-MS/IM), 2014-07
Australian approvals:
According to N1297
American and Canadian approvals:
Not MBS 5103/5153
Temperature indicating and regulating equipment acc. to UL 873, file no E31024 and Process control
1.
equipment acc. to CSA std. C22.2 no. 142-M1987.
2. Class I, Div. 2, Group A, B, C and D acc. to UL 1604, file no E227388 and Non-incendive electrial
equipment for use in class I, Division 2, Group A, B, C and D acc. to CSA std. no. C22.2 no. 213-M1987.
Must be powered by Class 2 power supply when used in Haz. Loc. Class I, Div. 2, Group A, B, C and D.
Ambient temperature 85 °C / 185 °F.
Temperature code T4.
MWP 600 bar / 8700 psi.
Stikket må ikke fjernes, når sensoren er aktiveret.
Plug must not be removed when sensor is
energized.
Stecker darf nicht entfernt werden, wenn der
sensor aktiviert ist.
Le connecteur ne doit pas être retiré lorsque le
capteur est encore sous tension.
El conector no debe retirarse cuando el sensor
esté activado.
Il connettore elettrico non deve essere scollegato
quando il sensore è in funzione.
IC.PI.P20.H6.53 / 520B6100
Kabelet må ikke udsættes for nogen mekaniske
skader, korrison, vibration, varme eller UV stråling.
Cable must neither be exposed for any mechanical
damage, corrosion, vibration, heat nor UV
radiation.
Kabel müssen weder auf mechanische
Beschädigungen, Korrosion, Vibration, Hitze noch
UV-Strahlung ausgesetzt werden.
Le câble ne doit être exposé à aucun dommage
mécaniques, à la corrosion, àux vibrations, à la
chaleur où aux radiations UV.
El cable no deber estar expuesto a ningún tipo de
radiación, daños mecánicos, corrosión,
vibraciones, calor ó UV.
Il cavo non deve essere esposto a danni meccanici,
corrosione, vibrazioni, fonti di calore o raggi UV.
2
Werbung
