Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.
Connecting the head
• switch the individual head on/off of your flash unit to the off position. If your unit does not have that
feature, swith your unit off.
• align the dot of the head plug with the dot on the unit. Insert the plug and turn the locking ring until it
clicks.
3.
Model lamp control and fuse
If the model lamp does not work :
• check the individual model lamp on/off control on the unit.
• check the light head fuse :
To change a fuse:
• switch the head off.
• unplug the head.
• unscrew the fuse holder insert (A2) using a screw driver if necessary.
• check the fuse and replace it if necessary. Use an 6.3A (slow blow) fuse.
4.
Focus control (Concept Z4 only)
Use the slide control (A5) to adjust the angle lit. Position 1 or 2 are recommended when using grid spots
for highest efficiency. Position 4 is recommended when using light boxes if no hot-spot is desired.
5.
Power control
Head power is controlled from the unit. Heads connected to Concept P4 or Concept B3 units with software
versions 4.0 and higher don't need to be dumped if power on the unit is lowered (the power is lowered
automatically). All other units need to be fired if power is lowered.
6.
Power selector (Concept Z4 only)
Use the full/half switch (A3) to switch from 4 capacitors to 2. You must trigger the head using the test
button (A1) when switching to half power.
7.
Charge indicator
The neon (A4) indicates that there is charge in the capacitor(s). It does not indicated 100% charge.
Observe the unit 100% charge indicator to read full recycle.
8.
Flash trigger
Trigger the head using the test button (A1). Other heads might also trigger if the unit photocell is on.
9.
Warranty exceptions
Damage to the flash tube, model lamp and Pyrex is specifically excluded by the Balcar warranty, except for
a manufacturing defect, as determined by Balcar.
Damage to the connector pins is also excluded by the Balcar warranty.
10. Warnings and Certification
Warnings:
There are no user serviceable parts inside the unit. Do not open the unit or attempt to repair it yourself.
Always unplug the head before manipulating the Pyrex shell, model lamp or flash tube.
CE Certification:
This unit is a "class A" unit. In a residential environment, this unit may cause electrical or radio
interference. In this event, the user may be asked to take appropriate corrective measures.
4
Donated to www.orphancameras.com
ENGLISH
Werbung
