Setup And Upgrade; Setup For Tv Mode; Wired Network Setup - Avermedia AVerLife ExtremeVision O272 Kurzanleitung

5 Setup and Upgrade

5.1 Setup for TV Mode

Please set the video source selector of
your TV to match the connection from
your AVerLife ExtremeVision Media Player
For example, if you use HDMI, set the TV
to use the correspondent HDMI input port.
START-UP PAGE
Check the TV display by going to "Setup" → "System Setup" → "TV Mode Setup"→
"Video Output". The default display of AVerLife ExtremeVision Media Player is
Composite (CVBS).
NOTE: You can press "SETUP" button on the remote control to enter Setup Main
Menu. And use
selection.
If you use HDMI, use the remote control and press "OUTPUT" button. You can run
through the TV modes to get the correct display mode.

5.2 Wired Network Setup

1.
Press "SETUP" button on the remote
control or select "SETUP" mode from
the Main Menu.
2.
Select "Network Setup" → "IP Setup",
and Enable DHCP or set your static IP
address according to your local
configuration.
to select an item and press "OK" button to confirm the
ENG-7
S