Ninja 566.500.001 Bedienungsanleitung Seite 39

VII. ASSEMBLING THE UNIT (suction of the product)
Depending on the size of the to be treated area, you can choose from
the following options:
a. Small surfaces
Fill a plastic bottle with the product you want to use (you can use one of
our bottles of 600 ml or 1000 ml, or any available bottle with a matching
thread), put the brass filter into the bottle and tighten it. The bottle
connection piece has a ball joint which adapts to the different
positions of the device during the treatment.
b. Large surfaces
In order to siphon the product from a reservoir, (bucket,
barrel,...) , have the brass filter connected and then insert
to the the extension tube of PVC of 9 m. The other end must
with the brass plunger must be put in the storage vessel.
Now the device is ready for use.
At the start-up put the flow controller to position 1 (wheel with size designation)
and increase it gradually.
Never submerge your 'Ninja' sprayer in a liquid.
VIII. INSTRUCTIONS FOR USE AND GENERAL INFORMATION
LITHIUM-ION BATTERY
The battery is fully charged when it has a voltage of 16.70 Volt. Make sure that the
voltage is not below 11 Volt, because will result in an irreversible damage to the
battery. A row of 3 (orange LED) lights provides information on the charging status:
3 LEDs lit
voltage > 15.5 volts
(charge status > 66 %)
2 LEDs lit
voltage between 14.5 and 15.5 volts
(charging status between 33 and 66 %)
1 LED lit
voltage between 14 and 14.5 volts
(charging status between 11 and 33 %)
CAUTION 1 blinking LED light: voltage < 14 volts (charge status < 11 %)
| 39
NINJA