Herunterladen Inhalt Inhalt Diese Seite drucken

General Instructions - Giorik 700 serie Installation Und Betriebsanleitung

Vorschau ausblenden Andere Handbücher für 700 serie:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

1. GENERAL INSTRUCTIONS

Read the instructions contained in this handbook carefully as they give important advice concerning safety of
installation, use and maintenance.
Keep this handbook for any further consultation by the various operators.
After having removed the packing, make sure the equipment is intact. In case of doubt, do not use the equipment and
contact professionally qualified staff.
Before connecting the equipment, make sure that the rating corresponds to that of electricity mains.
The equipment must only be used by staff trained in use of the same.
Before carrying out cleaning and maintenance, disconnect the equipment from the electricity supply system.
Switch the equipment off in the case of a fault or malfunctioning. For any repairs only contact an authorised technical
service centre and request the use of original spare parts.
Failure to observe the above may jeopardise safety of the equipment.
Connection, installation of the system and appliances, ventilation and fumes extraction must be carried out according
to the manufacturer's instructions, by professionally specialised staff. The current regulations of the fire brigade
should also be observed.
The electrical safety of this equipment is only ensured when it is correctly connected to an effective earthing system
as laid down by current electrical safety regulations.
This fundamental safety requirement has to be checked and, in case of doubt, an accurate check on the system by
professionally qualified staff requested. The manufacturer cannot be considered liable for any damage caused by
failure to earth the system.
This equipment must only be used for the purpose for which it was specifically designed.
Do not wash the equipment with direct, high pressure jets of water.
Do not obstruct the openings or vents for extraction or release of heat.
So as to avoid the risk of rust or chemical attack in general, the stainless steel surfaces have to be kept properly
clean.
Clean the parts in stainless steel daily with warm, soapy water, then rinse thoroughly and dry carefully.
On no account should the stainless steel be cleaned with steel wool pads, brushes or scrapers in standard steel, in
that they could deposit ferrous particles which, by oxidising, cause rust spots. Stainless steel wool can, if necessary,
be used in the direction of the satin finish.
Should the equipment not be used for long periods, wipe all the steel surfaces vigorously with a cloth moistened with
Vaseline oil in order to apply a protective layer; also air the rooms periodically.
The manufacturer of the appliance declines every responsability for possible mistake contained in this booklet
imputable to printing or transcription errors. It also reserves the right to bring changes to the product if retains useful
or necessary without jeopardizing the essential characteristics.
The manufacturing company declines any and every responsability if the rules brought in this manual are not strictly
observed.
The manufacturer of the appliance declines all responsibility for damage caused by faulty installation, tampering with
the appliance, improper use, poor maintenance, failure to observe local regulations and unskilled use.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis