Technical Data - Husqvarna QC80 Bedienungsanweisung

Fault codes
Troubleshooting the battery and/or the battery charger
during charging.
(5), (6), (9)
LED
Possible
display(Applies
faults
only QC80F)
Error LED is out
/ battery charger Blown fuse
doesn't work
Error LED Temperature
flashing deviation.
Cell difference
Error LED is lit
too much (1V).
• If the warning LED on the battery charger lights solid
red, there is a fault with the charger. Send the charger
to a Husqvarna service workshop. (5)
Disposal of the battery, battery charger
and machine
Symbols on the product or its packaging indicate that this
product cannot be handled as domestic waste. It must
instead be submitted to an appropriate recycling station
for the recovery of electrical and electronic equipment.
By ensuring that this product is taken care of correctly,
you can help to counteract the potential negative impact
on the environment and people that can otherwise result
through the incorrect waste management of this product.
For more detailed information about recycling this
product, contact your municipality, your domestic waste
service or the shop from where you purchased the
product.

Technical data

Technical data
Battery charger QC80
Mains Voltage, V 100-240
Power,W 100
Fuse, A
BATTERY HANDLING
Possible action
Replace the blown
fuse with a new one.
Remove the screw
and split the plug
and change fuse.
Use the battery
charger only when
the surrounding
temperature is
between 5 °C and
40 °C.
Contact your
service agent.
QC80F
10-15
95
16
Battery Cells (pcs) Ah
BLi10 10
BLi20 20
BLi80 10
BLi110 20
BLi150 20
BLi520x 70
BLi940x 90
EC Declaration of Conformity
(Applies to Europe only)
Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-
36-146500, declares under sole responsibility that the
battery chargers, Husqvarna Quick charger 80 from
2016's serial numbers and onwards (the year is clearly
stated in plain text on the rating plate with subsequent
serial number), are in conformity with the requirements of
the COUNCIL'S DIRECTIVES
- of February 26, 2014 "relating to electromagnetic
compatibility" 2014/30/EU.
- of June 8, 2011 on the "restriction of use of certain
hazardous substances" 2011/65/EU.
- of February 26, 2014 "relating to electrical equipment
designed for use within certain voltage limits" 2014/35/
EU.
The following standards have been applied:
EN 60335-1:2012, EN 60335-2-29:2004, EN 55014-
1:2010, EN 55014-2:2009, EN 61000-3-2:2015, EN
55022:2011
Huskvarna 15 March 2016
Lars Roos, Development manager (Authorized
representative for Husqvarna AB and responsible for
technical documentation.)
Charging level
80% 100%
2 50 min 70 min
4 100 min 140 min
2,1 50 min 70 min
3 80 min 105 min
4,2 110 min 140 min
7.5
14,4 7 hours
hours
13 13.5
26,1
hours hours
English
–
5