Mac Installation - J5create JUC500 Benutzerhandbuch

WORMHOLE SWITCH

Mac installation

EN
Please follow the instructions below to install the wormhole switch driver.
Connect one end of the wormhole switch to a standard
two computers. Connect the other end of the wormhole switch to a
the second computer.
When you initially connect the wormhole switch to the Mac computer the Keyboard
Setup Assistant window will pop up, follow the steps to select the keyboard type.
When both ends of the JUC500
to start the software. If the Enable access for assistive devices window appears on the
screen, click Yes to continue.
Please run the steps above on both computers. If the other computer is a Windows , please
refer to the Windows installation guide.
When the wormhole switch is connected properly the wormhole launch page will be shown.
The wormhole switch icon will appear in the lower right-hand corner. If the two units are
connected to the
USB 3.0; however, if a
TM
indicating that the transmission speed is
computer is not connected.
6. Please set the position of the other PC. Please click on the wormhole switch
to open the wormhole switch toolbar. Then click on The Position of Other PC and select
the screen location according to where you want your mouse to flow from one screen
to the other.
are plugged into the computers'
USB 3.0 or
TM
USB 2.0 port is connected to one end, then this
TM
USB
TM
6
USB or port on one of the
TM
USB or
TM
USB
this icon will appear, indicating the transmission
icon appears it means the other
USER MANUAL
port on
ports, the
TM
icon
,
icon will appear
or icon