Windows Installation - J5create JUC500 Benutzerhandbuch

WORMHOLE SWITCH
WORMHOLE SWITCH

Windows installation

Please follow the instructions below to install the wormhole switch driver.
Connect one end of the wormhole switch to a standard USB or
two computers. Connect the other end of the wormhole switch to a
the second computer.
The device will automatically start the wormhole switch software installation on both
computers. An AutoPlay option window may appear. Please double-click the wormhole icon
to start the application.
3. If the User Account Control window appears on the screen, click Yes to continue.
Please run the steps above on both computers. If the other computer is a Mac , please refer
to the Mac installation guide.
When the wormhole switch is connected properly the wormhole launch page will be shown.
The wormhole switch icon will appear in the lower right-hand corner. If the two units are
connected to the USB
TM
USB 3.0; however, if a
TM
indicating that the transmission speed is
computer is not connected.
6. Please set the position of the other PC. Please click on the wormhole switch
to open the wormhole switch toolbar. Then click on The Position of Other PC and select
the screen location according to where you want your mouse to flow from one screen
to the other.
3.0 or port this icon
USB 2.0 port is connected to one end, then this
TM
USB the
TM
5
3
USER MANUAL
USER MANUAL
port on one of the
TM
USB or
TM
will appear, indicating the transmission
icon appears it means the other
or
EN
port on
icon will appear,
icon