Before Starting The Equipment; Replacing The Power Cable - Ergo tools Pattfield E-BH 950 Bedienungsanleitung

Anleitung E_BH_950_SPK7:_

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
Use a detector to localize pipes and/or cables in
walls with concealed electric, water or gas lines.
Before you plug in the machine, check that your
mains voltage is the same as that marked on the
rating plate.
5.1 Fitting and changing a bit (Fig. 2)
Clean the bit and coat it with a little machine
grease before you insert it.
Pull back the locking sleeve (A) and hold in this
position.
Insert the dust-free bit with a twist as far as it
goes into the chuck. The bit will automatically be
locked in place.
Pull on the bit to check that it is secure.
5.2 Removing a bit (Fig. 3)
Pull back the locking sleeve (A), hold and pull out the
bit.
6. Starting up (Fig. 1/Pos. 3)
6.1 Switching on/off
Switching on:
Press On/Off switch (3).
Switching off:
Release On/Off switch (3).
6.2 Additional handle (Fig. 1/Pos. 4)
For safety reasons you should always use the
hammer drill with the additional handle.
For a secure posture during work you should turn the
additional handle. Twist the additional handle
anticlockwise and turn.
Then fix the additional handle by twisting again.
6.3 Depth stop (Fig. 1/Item 5)
Slacken the thumb screw on the additional handle
and insert the straight part of the depth stop into the
hole in the additional handle. Set the depth stop and
retighten the thumb screw.
09.01.2008 14:21 Uhr Seite 11
6.4 Dust collector (Fig. 4)
Before you start any hammer drilling work directly
over your head, slide the dust collector on the bit.
6.5 Hammer stop (Fig. 5)
The hammer drill comes with a hammer stop for
smooth pre-drilling.
Turn the lever switch (6) to the right to position
(b) to switch off the hammer mechanism.
To turn the hammer mechanism back on you
have to turn the lever switch (6) back to position
(a).
6.6 Rotation stop facility (6)
The rotation function of the hammer drill can be
switched off for chiseling jobs.
To do so, press the button (d) on the lever selec-
tor (7) and turn the lever selector (7) so that the
mark (c) coincides with the arrow (a) on the
machine housing.
To reactivate the rotating function you must
again press the button (d) on the selector lever
(7) and turn the lever selector (7) so that the
mark (b) coincides again with the arrow (a).
Important:
You only need to apply minimal pressure for hammer
drilling. Do not apply too much pressure as this will
put unnecessary strain on the motor. Check the
hammer drill at regular intervals.
Re-sharpen or replace bits whenever blunt.

7. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
GB
11