LaserLine ThermoSpot Pocket Bedienungsanleitung Seite 8

a
b
c
d
a Hold function
b Battery status
c Measured value display
d MIN or MAX value
during the measurement
3
Continuous measurement / Hold
For continuous measurement
activate the laser (see figure)
and keep the button pressed.
A quality product from
GmbH & Co. KG, Donnerfeld 2, 59757 Arnsberg,
Germany, Tel.: +49 2932 638-300, Fax: -333, www.laserliner.com
Rev18W45
Nicht in den Strahl blicken.
650 nm · EN 60825-1:2014/AC:2017
Measurement procedure notice
This infrared temperature instrument detects the temperature of
various surfaces and materials. A built-in sensor head detects the
material-specific infrared rays emitted by every object. The amount
of these emissions is determined by the material's emission coeffi-
cient (0 ... 1). This instrument is permanently set to an emission coef-
ficient of 0.95, which is applicable to most organic materials as well
as plastics, ceramics, wood, rubber and stone. Please ensure that the
space between the instrument and surface to be measured is free of
disturbances (steam, gas, contamination, glass).
Laser
The laser is a targeting aid to
sight the location for the infrared
measurement. Only the surface's
temperature is measured. Set the
optimum measuring distance for
the measured spot (12:1) such that
it is completely within the target
object.
08
EN
e
f
9V 6LR61
(9-V-block)
Laserstrahlung!
Laserklasse 2 · < 1 mW
g
e
Laser beam switched on
f Unit of measurement °C
g MIN/MAX switching
h Laser output
i ON / Measure
Release the button as soon
as the target laser pinpoints
the measurement location.
The measured value is held.
A quality product from
Germany, Tel.: +49 2932 638-300, Fax: -333, www.laserliner.com
Rev18W45
h
i
9V 6LR61
(9-V-block)
GmbH & Co. KG, Donnerfeld 2, 59757 Arnsberg,
Laserstrahlung!
Nicht in den Strahl blicken.
Laserklasse 2 · < 1 mW
650 nm · EN 60825-1:2014/AC:2017