Technical Data - Beper 40.452 Betriebsanleitung

EN
Steam Hair Straightener Use instructions
• Be careful not to direct the steam to the skin to avoid the risk of burns.
• Do not use the product near sources and / or containers of water.
• Be careful that the power cord does not come into contact with the hot parts of the product.
• Always place the product on heat-resistant surfaces.
• Keep the product away from flammable objects (clothes, towels ...).
• This product is only suitable for hair. Do not use on wigs and / or animal hair.
• Do not leave the hair in the plates for more than a few seconds at a time, as they can be damaged.
• Never leave the power cord wrapped around the product.
• Allow the product to cool before storing and / or cleaning.
• For safety reasons, the product will automatically turn off after one hour of use.
FILLING THE TANK (FIG.2):
• Remove the tank at the top of the appliance using the button.
• Fill it with water, preferably distilled (after raising the small white rubber cap), by using the measuring cup
supplied.
• Replace the tank, making sure that it is properly closed and positioned correctly.
• Check that the hands and the outside of the tank are perfectly dry.
• If the tank needs to be filled again during operation, unplug the appliance and wait until the appliance cools
down.
• Never open the tank when the appliance is hot.
• Observe a heating time of 2-3 minutes before using the steam function.
OPERATION
USE (without steam):
• Wash your hair and make sure they are dry. The smooth effect will be better if your hair is clean.
• Comb your hair thoroughly and remove any knots.
• Be careful not to put too much hair inside the plates.
• Plug in the product and press the ON / OFF button.
• The product starts to heat up, the operating light will start blinking, and will turn off when the selected tempe-
rature is reached.
• Use the +/- key to set the appropriate temperature.
In general, it is suggested to choose a lower temperature (180 ° C) for thin, discolored and / or sensitive hair, and
a high temperature (230 ° C) for curly hair, thick and / or difficult to comb.
• Continue to smooth each separate, previously separated, start from the roots to the tips, without stopping to
avoid burning your hair.
• It is recommended that the hair be cooled before combing it, to avoid compromising the result.
• When finished, switch off the appliance using the ON / OFF button and disconnect the appliance.
USE (with steam):
• Make sure the tank is full.
• Activate the steam function with the appropriate switch.
• Proceed as described in "NO-STEAM USE".
CLEANING:
• Unplug the appliance and allow it to cool completely.
• Always empty the tank after each use.
• Clean the plates with a damp, gentle cloth without detergent to preserve the optimum quality of the plates. Do
not scratch the plates.
• Use preferably distilled water to fill the tank. If not, disconnect the appliance periodically.

TECHNICAL DATA:

25-30W power
Power supply 110-240V - 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
9