Safety information / Assembly
is complete and whether the par-
asol stand has been damaged.
The umbrella stand is not a toy.
Children's fingers or feet could
be pinched.
Never leave the umbrella stand
unattended – the umbrella tip-
ping can result in serious
injuries. Please remember, de-
pending on the wind force and
diameter of the umbrella, this
umbrella stand could also be
too light.
Be sure to close your umbrella if
wind emerges.
Be sure to follow your country's
national regulations in addition
to the rules specified in these in-
structions.
Assembly
You need:
– Size 17 socket key
– 1 Person to assist you
Assembling the base
Place the base
have a second person support it
firmly. Injuries may otherwise
occur!
14 GB/IE
upright and
7
Insert the screw with spring
washer, ring washer and rubber
washer
into the base from be-
1
low. Please note the position of
the washers (see Fig. A)!
Place the large rubber washer
with a centre hole over the
2
screw protruding at the top
(see Fig. B).
Secure the screw
using a socket key and place the
stand tube
onto the screw
3
from the top, and slightly screw in.
Align the rubber washer
low the stand tube
the screw
with the socket key
1
(see Fig. C).
Note: The clamping plate
premounted to protect the um-
brella pole (see Fig. D). Please
do not remove.
Using inserts
Use the inserts
5
size of your umbrella pole.
Insert the necessary inserts
the stand tube
3
the respective insert is intended
to leave room for the clamping
plate
(see Fig. E).
4
from below
1
1
be-
2
. Tighten
3
is
4
to match the
in
5
. The groove of