Zipper Maschinen ZI-KGS210K Betriebsanleitung Seite 27

 Do not use the machine with damaged switch
 Never use the power cord for transportation or manipulation of the machine!
 Never leave Before starting the machine remove any adjusting wrenches and
screwdrivers
 Use a clip or clamping jaws to secure the workpiece
 Do not fix the workpiece with your hands
 Rotating parts can cause severe cut injuries
 Keep the saw blades sharp and clean, so they get stuck less often and are easier to
guide
 Keep any machine that is not being used out of reach of children
 Connect the dust extraction device to
 Do not use the cable to remove the plug from the socket.
 Protect the cable from heat, oil and sharp edges
 Even Lasers with relatively small output can harm your eyes! Therefore:
 Never look directly into the laser or into the laser beam!
 Never direct the laser beam towards reflecting surfaces, persons and animals.
 Do not manipulate the laser device!!
 Use only saw blades that are suitable for the use with the KAP machine, especially
regarding technical parameters and which are tested and comply with the directive
EN 847-1.
 Deflected, defect or worn saw blades have to be replaced immediately.
 Blunt saw blades have to be sharpened or replaced.
 Blunt saw blades highly increase the danger of kickback!
 Assure yourself that the saw blade is correctly mounted and does not touch the base
plate.
 Do not stop the saw blade by touching it on the side. This will ruin the drive
mechanism.
 Do not manipulate or remove the saw blade protecting cover!
 Do not fix small workpieces by hand, instead only use the downholder.
 No material feed, no material removal, no adjustments or other activities when saw
blade is running.
 Do not position your hands near the saw blade or in a way that they could slip into the
cutting line.
 Long workpieces have to be supported by the double bar guide.
 Take especially care when cutting round workpieces!
 Check the workpiece for nails, clamps and other material!
 Just cut one workpiece at once. Do not stack or attempt to cut several work-pieces in
one cutting operation!
 Do not cut firewood
 Wear gloves when handling the saw blades and rough materials. It is recommended
that saw blades, whenever practicable be carried in a container.
 Make sure that the speed indicated on the saw blade is at least as high as that on the
saw speed specified.
 Be sure to use only those spacers and screw rings, which are suitable for the purpose
specified by the manufacturer.
 No reload, remove or adjust workpieces, or material remains with the machine
running!
 Do not place hands in near circular saw blade or in a position where they could slip
direction circular saw blade!
 The use of other application tools and other accessories can mean a risk of personal
injury.
 Let your power tool repaired by a qualified electrician
 The machine does not require extensive maintenance. If malfunctions and defects
occur, let it be serviced by trained persons only.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-KGS210K / ZI-KGS250K
SAFETY
27