Preventing Equipment From Falling Over - Pioneer PDK-TS15 Bedienungsanleitung

Preventing Equipment from Falling Over

After installing the stand, be sure to take special care to ensure that the equipment will not fall over.
Because of the Plasma Display's weight, if it could fall down, this can result in injury.
For safety, be sure to take special care to ensure that the Plasma Display will not fall over.
Stabilizing on TV table or other location
Stabilize the equipment as shown in the diagram using
screws that are available on the market.
Note
A TV table with adequate strength, width and depth
should always be used to support the Plasma Display.
Failure to do so could result in falling over.
To stabilize the Plasma Display on a TV table, use screws
that have a nominal diameter of 6 mm (1/4 inch).
Select the appropriate screws after consulting a profes-
sional installer if necessary.
Position of table screws
When stabilizing the stand to a TV table, use nominal
diameter 6 mm (1/4 inch) with a length above
20 mm (13/16 inch).
Unit: mm (inch)
12
En
Min. 20 mm
(13/16 inch)
300 585
(11-13/16)
(23-1/32)
Side View
Using a wall for stabilization
1
Attaching falling prevention bolts (hooks)
to the Plasma Display.
2
Using strong cords to stabilize it
appropriately and firmly to a wall, pillar, or
other sturdy element.
Perform this work in the same way on the left and right
sides.
Note
Use hooks, cords, and fittings that are
available on the market.
Recommended hook:
Nominal diameter M8
Length 12 mm to 15 mm (1/2 inch to
5/8 inch)
1
Hook
2
Cord
Fitting
Caution
• A table or an area of the floor with adequate strength
should always be used to support the Plasma Display.
Failure to do so could result in personal injury and
physical damage.
• When installing the Plasma Display, please take the
necessary safety measures to prevent it from falling or
overturning in case of emergencies, such as
earthquakes, or of accidents.
• If you do not take these precautions, the Plasma
Display could fall down and cause injury.
• The screws, hooks, chains and other fittings that you
use to secure the Plasma Display to prevent it from
overturning will vary according to the composition and
thickness of the surface to which it will be attached.
• Select the appropriate screws, hooks, chains and other
fittings after first inspecting the surface carefully to
determine its thickness and composition and after
consulting a professional installer if necessary.
12 mm to 15 mm
(1/2 inch to 5/8 inch)