First Time Launch; The Remote Control - Avermedia AVerLife HD Theater A211 Benutzerhandbuch

3.1 First time Launch

The first time you power on the AVerLife HD Theatre unit, it will automatically display the Setup Wizard:
Press OK.
Then the AVerLife HD Theater will start to
scan the channels in your area.
After scanning for available channels,
you can start to watch TV.

3.2 The Remote Control

The diagram below shows the remote control unit layout.
1
3
5
7
9
11
13
15
17
19
22
ll 請增加一個城市
h of
sts.)
Press OK to select a country and city
for weather information display.
* Please set up City at first if you want to show the
"RSS weather". Otherwise, there will be no information
shown in RSS weather.
Choose your country and menu language.
In "IP", choose "Static" to customize the
IP settings or "DHCP" to automatically
configure the available IP address.
Then press Next.
1.
2.
2
4
6
8
3.
10
12
4.
5.
Numeric Buttons
14
6.
16
7.
18
20
8.
21
9.
23
10.
11.
ENG-5
Select a country and press OK.
Press Next to continue the setting.
Select a city and press OK.
Turn the unit on/stand-by
*Press Power button to turn on the model;
press again to turn into stand-by mode.
Stand-by mode: Power-saving sleep mode
(This function is not supported)
(This function is not supported)
Launch Weather widget
(This function is not supported)
(This function is not supported)
Display the current program information. (DTV
only)
To select a TV channel
Go to the home menu.
Choose a channel number over 100.
View EPG information.
Go to the previously selected channel
Open the channel list.
Use the arrow button to navigate all
on-screen items. Use OK to confirm the
selection.
User's Manual