Instructions; Maintenance - Zen Aroma ELEGANSIA V2 Bedienungsanleitung

IV.

INSTRUCTIONS

Preferably, place the diffuser in the room half an hour before switching it on so that it can
adjust to the ambient temperature.
Step 1: Remove the cover.
Step 2: Make sure the reservoir is clean and fill the reservoir with a maximum of 100 ml of
clean water. (Please put demineralized water and essential oils without alcohol).
Step 3: Pour a few drops of essential oil into the base reservoir. NOT MORE THAN 3 DROPS.
Step 4: Put the stopper cover then the cover.
Step 5: With dry hands, plug the adapter and press the button to start the diffusion and light.
This model incorporates a smart control system integrated in the base. Just
press on glass cover to launch different operating modes:
- 1st press: launch the diffusion and color-changing lighting.
- 2nd press: set the color of the lighting.
- 3rd press: stop lights and diffusion.
CAUTION: Do not tilt the unit when it is working. Do not fill in or
empty the tank when the diffuser is working. Do not put more than
3 drops of essential oils.
WARNING: DESPITE THE SAFETY CUT-OUT DEVICE THAT TURNS THE TRANSDUCER OFF,
AVOID LEAVING THE POWER SWITCHED ON TO THE DEVICE WHEN YOU ARE NOT USING IT.
TO STOP THE DIFFUSER COMPLETELY, UNPLUG THE UNIT FROM THE POWER SUPPLY.
V.

MAINTENANCE

If the water contains too much mineral, calcium or/and too much magnesium it can leave a
"white powder" in the device. If this scum is deposited on the ceramic disk, the device will
be prevented from operating properly.
The lifetime of the ceramic disk is limited (about 3000 hours). After some time of operation
the device will generate less mist. This is normal wear of the ceramic disk.
We recommend:
1) Use demineralized water and essential oils without alcohol each time.
2) Cleaning the reservoir every 2 days and cleaning the ceramic disk each week.
3) Changing the water in the reservoir regularly. Don't leave it there for more than 2 days.
4) Cleaning the whole diffuser (see the explanation below) and making sure that all the parts
are completely dry when it is not being used.
EN
10