Fcc Statement; Introduction; Contents - Maytronics Dolphin WAVE 300 XL Gebrauchsanweisung

2. fCC STaTemenT

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the party responsible for
compliance (Maytronics Ltd.) could void the user's authority to operate the equipment.

3. inTroduCTion

This user guide describes how to use your MMI operating console for the Dolphin Wave robotic pool
cleaner. The interactive, state-of-the-art MMI (Maytronics Machine Interactive) control console enables
full control of the robot and allows you to determine the cycle time, operation delay, and cleaning
scan that the robot performs. It also enables diagnosis of various technical functions and parameters.
The console houses a remote control unit for manual operation and temporarily overriding automatic
cleaning operations.
The Dolphin Wave robot is designed to handle 4 different swimming pool configurations and when
these are set, the pool configurations are stored in the MMI's memory. The robot is preset in the
factory with specific default pool settings, which can be reset. Please refer to the first Main Menu
screen, Figure 6 and Customized Settings, page 7.

4. ConTenTS

Carefully remove all the items from the shipping box and check them against the packing list.
You should have:
• Documentation and accessories
• Un-assembled Caddy for storing and carrying the Dolphin Wave robot
• MMI console (includes remote control unit)
• Dolphin Wave robot and floating cable
• Filter Bags:
2 fine porosity filter bags assembled in the Dolphin Wave robot for day-to-day cleaning
2 ultra-fine filter bags for fine dust particles
2 loose weave filter bags for rough debris
• Power supply unit
Wave XL User Instructions
|
3