Technical Data - Magnusson 3663602850830 Bedienungsanleitung

05 Metal Detection
Switch the detector on, select the metal detection mode (
Place the detector on the surface to be scanned and move it slowly in a sideways direction. Keep fingers clear of the sensor to
avoid inaccurate readings. When a metallic object is detected below the sensor, the detection signal strength bars (F) will illuminate,
showing the amplitude of the received signal. 100% indicates a strong reading. If the object is directly beneath the sensor, the
detection proximity sensor (E) will also be fully illuminated. The detector will also show an approximate distance (in cm) to the metal
being detected. Repeat the process, moving the detector in the other direction to confirm material position.
The detector will also indicate if the metal is magnetic or non-magnetic, as shown below:
Magnetic -
Non-Magnetic -
NOTE!
• When used in metal detection mode, foil backed plasterboard will cause
inaccurate readings.
06 Live Wire Detection
Switch the detector on, select the live wire detection mode (
Place the detector on the surface to be scanned and move it slowly in a sideways direction. Keep fingers clear of the sensor to
avoid inaccurate readings.
When a live wire is detected below the sensor, the detection signal strength bars (F) will illuminate, showing the amplitude of the
received signal. 100% indicates a strong reading. The red LED will flash and a beeping will be heard. If the wire is directly beneath
the sensor, the detection proximity sensor (E) will also be fully illuminated. Repeat the process, moving the detector in the other
direction to confirm wire position.
CAUTION!
Live wire detection will only work on a wire containing a standing voltage or a current
carrying circuit. If no voltage is present, use in metal detector mode.
WARNING! Live AC wires cannot be detected in shielded cables, wires in metal
pipes or conduit, or behind high density walls.
Technical data
Maximum scanning depth:
Ferrous metals 80 mm
Non-ferrous metals (Copper) 60 mm
Copper conductors (live) 50 mm
Wood 20 mm
Power supply: 9V battery (6F22 or 6LR61) not included.
SAAM10538 instruction A5 R V8.indd 7
) and then calibrate as detailed above.
) and then calibrate as detailed above.
7
19/12/2018 14:12