Before You Start - Palram Harmony Handbuch

EN
IMPORTANT
Greenhouses Anchoring Kit for: Harmony, Hybrid, Mythos, Octave, Balance, Essence
PALRAM's Greenhouse Greenhouses
Please read these instructions carefully before you start to assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.

Before you start

It is highly recommended to be assisted by a second person in some steps.
Sort the parts and check according to the contents parts list.
The product must be positioned and fixed on a leveled surface.
Make sure that screws and anchors suit the surface type.
Please be safe during assembly.
Safety
This product should be mounted to the ground as shown in these instructions
in order to ensure greenhouse's stability and appropriate wind resistance.
Some parts may have sharp edges. Please be careful when handling
components.
Always wear gloves, eye protection, and long sleeves when assembling or
performing any maintenance on your product.
If using a stepladder or power tools please ensure that you follow the
manufacturer's safety advice.
Do not lean the stepladder against the greenhouse.
Do not stand on the greenhouse roof/panels
To prevent injuries, do not allow children to play under the greenhouse
during assembly.
Do not attempt to assemble the greenhouse in windy or wet conditions
You will need
To assembly this product
(these items not supplied)
x2
Care and Maintenance
Periodically check the product to assure that it remains stable.
Keep roof clean of snow.
During Assembly
During assembly you will encounter the information icon, please
refer to the relevant assembly step for additional comments and
assistance.
Step 4 : cable should not be placed over the window vent, in order not to
block window opening
Step 5 : According to the ground surface type, follow the appropriate
mounting procedure.
Option 1 : soft/ground installation.
Option 2 : for hard surfaces (concrete or wood)
Step 7 : After the product has been installed, fasten the steel cable by
turning part #7332
Tighten all screws when completing assembly.
It is possible to cut the rest of the steel cable only after a final decision on
the mounting location has been made.