Shut-Down Procedure - WEPA TOPITEC AUTOMATIC 025620 Bedienungsanleitung

4.5 Shut-down procedure

Danger
Prior to any cleaning, maintenance or repair tasks
(to be performed by an electrician), shut down the device as described
below:
1. Lower the slide to its initial position and remove the jar.
2. Disconnect the TOPITEC
• Set the main switch (power switch) to position "0".
• Secure the TOPITEC
by disconnecting the power cable from the socket.
2.1 For maintenance and repair work only:
• Check the device to ensure that it is fully de-energized.
• Cover or otherwise insulate adjacent parts that remain powered.
Danger
Non-compliance can result in serious or even fatal injury
(from accidental voltage transfer)!
Capacitors might retain some dangerous residual voltage.
Before commencing work, check the capacitors and de-energize them slowly.
If a task cannot be performed when the device is shut down as described
above, contact your dealer or carry out the task with due regard to the inter-
nal risk assessment.
AUTOMATIC from the power supply:
®
AUTOMATIC against inadvertent restart
®
25