Tecknet BLUETEK Benutzerhandbuch Seite 4

Using your BLUETEK™ iEP1500 Power Bank
1. Charging the power bank
You can use the provided "USB to Micro USB cable" to charge the
BLUETEK™ iEP1500 Power Bank from a USB power source .
Note: While the BLUETEK™ iEP1500 Power Bank is being charged,
the blue LEDs will flash . Once the Power Bank is fully charged, all
LEDs will light up and the Power Bank will stop charging. Disconnected
from its power source, and your power bank is ready for charging now.
The Power Bank can provide power output during the charging period.
2. Recharging your devices
There is an on/off power switch on the BLUETEK™ iEP1500 Power
Bank. Upon pressing the " switch button " the LED power indicator will
inlluminate for 2 to 3 seconds. After that, the Power Bank will start
charging your devices. To stop charging your device, simply disconnect
the device from the BLUETEK™ iEP1500 Power Bank. The power output
will remain active for 30-35 seconds and will automatically switch off if the
Power Bank is not connected with any device within this period.
Battery Capacity Indicator & LED Light Switch Button
The LED power indicators provide information about the battery
charging status and battery power level:
Press the "switch button" to check power level, the LEDs will
illuminate for 30~35 seconds.
LEDs indicate:
1 LED Flashes: <15% Power
2 LED on: 16-30% Power
3 LED on: 31-45% Power
4 LED on: 46-60% Power
5 LED on: 61-80% Power
6 LED on: 81-100% Power
EN