The Remote Control; Installing/Replacing The Remote Control Battery - Opalum FLOW series Bedienungsanleitung

Opalum® FLOW series
Opalum® STREAM series
Owner's Guide

4. The remote control

1
2
3
4
NOTE: Before using the remote control install batteries and remove the front protection film. Not
removing the protection film may decrease or block the touch sensitivity.
4.1 Installing/replacing the remote control batteries
To install/replace the remote control batteries the remote control must be
opened using included opening pin (figure 1) or similar thin sturdy object.
1. Insert the metal pin in the hole at the back of the remote control marked
"Push here to open".
2. Push firmly inwards until the front panel and housing is separated as
depicted in figure 2.
3. Install/replace the batteries. Always replace both batteries at the
same time. Use AAA size batteries.
NOTE: Batteries must be inserted with correct polarity according to the
picture on the battery holder.
4. Re-assemble the front panel and housing.
Make sure to align both parts properly using the
alignment tab, see figure 3. The parts will then
magnetically snap together.
Sound Technology
1. Status indicator
Indicates the current status using different
colors and flash modes. For details see section
"The status indicator".
2. Power on/off button
Press this button to turn system on or off.
3. Change input source plus button
5
Press this button to change to next input source.
4. Change input source minus button
Press this button to change to previous input source.
5. Increase volume button
6
Press this button to increase the output sound volume.
6. Decrease volume button
Press this button to decrease the output sound volume.
Fig 3
w w w . o p a l u m . c o m
Fig 1
Fig 2
19