Villaware BLVLLAZ05H Bedienungsanleitung Seite 6

before using your blender
• Before using your VillaWare
blender instructions" to disassemble the jar assembly and wash the lid, feeder cap, blade
and threaded bottom cap in warm, soapy water or in the top rack of the dishwasher.
Rinse and dry well.
ASSEMBLY INSTRUCTIONS:
THE BLADES ARE EXTREMELY SHARP. HANDLE CAREFULLY.
Follow the assembling instructions listed below before using your VillaWare
1
Figure
• Turn jar upside down so
that the small opening is
at the top (Figure
Figure 4
• Ensure secure fit of
sealing ring between
jar and blade assembly
(Figure 4).
• Place jar assembly onto
motor base (Figure 7).
Curve on jar skirt will
be centrally located over
dial.
Blender for the first time, follow the "after using your
®
Figure 2
• Put the sealing ring
around the blade
). assembly (Figure 2).
1
Figure 5
• Place jar skirt facing down
around jar (Figure 5).
Figure 7
• Place lid with feeder cap
on jar (Figure 8).
• Place neck of blade
• Place threaded bottom
Figure 8
5
Blender:
®
Figure 3
assembly on the rim of
the small jar opening. Tilt
blades inside jar. NOTE:
Blades may drag slightly
against jar. (Figure 3).
Figure 6
cap over small jar
opening and turn it
clockwise to tighten
(Figure 6).