Olimpia splendid B1015 Handbuch Für Installation, Gebrauch Und Wartung Seite 23

2.3.3 UNICO AIR INVERTER MODEL
The slot in which to house the B1015 card is located on the machine's front panel on the top right.
• Disconnect air conditioner's power supply.
• Remove the filters above the evaporating unit (Fig. 5 Ref. A).
• Remove the machine from the wall bracket.
• Remove the 3 screws indicated in Fig. 5.
• Remove the machine from its joints by sliding it out and turning it as shown in Fig.6.
• Place the B1015 card into the appropriate slot (Fig. 9) and then tighten its screws (Fig. 9 Ref. A) to secure it.
• Route the communication cable into the appropriate slot behind the finned heat exchanger (Fig. 9 Ref. C).
• Connect the communication cable to the serial port (Fig. 9 Ref. D) located behind the air conditioner on the
top right.
• Refit the machine's front cover and secure everything with the 3 screws (Fig. 5).
• Insert the filters above the evaporating unit (Fig. 5 Ref. A).
• Refit the machine on the wall.
2.3.4 PRO INVERTER UNIQUE MODEL
The slot in which to house the only B1015 card is located behind on the machine's front side at the top right.
• Disconnect the air conditioner power supply.
• Raise the air intake grid (Ref. B) and remove the two screws (Ref. A Fig.10).
• Slide out the right-hand door (release it using a screwdriver) and the left-hand door (Ref. A Fig.11) from the
front cover.
• Turn the flap (Ref. B Fig.11) and remove the three screws (Ref. A Fig.12) and the two screws (Ref. A Fig.13).
• Remove the front cover (Fig.14).
• Insert the B1015 card into the appropriate slot (Fig.15) and then tighten the relating screws (Ref. A Fig.15) to
fix it.
• Connect the communication cable to the serial connector of the air conditioner (Ref. A Fig.16) and to the
respective connector on the B1015 card (Ref. E Fig.1) as specified in paragraph 2.2.
• Refit the machine's front cover and secure everything using the seven screws.
• Close the air intake grid.
2.3.5 TOWER UNIQUE MODEL
The slot in which to house the only B1015 card is located behind the front panel.
• Disconnect the air conditioner power supply.
• Remove the two fixing screws of the front panel (Ref. A Fig.17) and the front panel (Ref. A Fig.18).
• Position the spacer bushes (Ref. A Fig.19) and then secure the cards using the two relating screws (Ref. B
Fig.19).
• Connect the communication cable to the serial connector of the air conditioner (Ref. A Fig.20) and to the
respective connector on the B1015 card (Ref. E Fig.1) as specified in paragraph 2.2.
• Close the front panel and secure it using the relating screws.
GB
23
WIRELESS B1015